Articles, Blog

Slide Culture Technique for Fungi – Amrita University

August 16, 2019


Slide Culture Technique for Fungi
Slide culture method is a rapid method of preparing fungal colonies for examination
and identification. This method permits the fungi to be studied virtually insitu with
as little disturbance as possible. Fungi are identified mostly by close examination of
its morphology and the characteristics it possess. In slide cultures, we are growing
the fungi directly on the slide on a thin film of agar. Materials required:
7-10 day old fungal culture Sterile sabourauds agar plate
Sterile Petri dish in which a sterile filter paper of 9cm diameter is placed
U-shaped glass rod placed in the petriplate Microscope slides and coverslips
Scalpel and Inoculating loop 95% ethanol
Lactophenol cotton blue stain Sterile distilled water Procedure for Slide Culture Preparation Arrange all the materials in the laminar chamber
(DSCO6119) Aseptically, with a pair of forceps, place
a sheet of sterile filter paper in a Petri dish
Place a sterile U-shaped glass rod on the filter paper
Pour sterile water on filter paper to completely moisten it.
Gently flame a scalpel to sterilize and cut a 5 mm square block of the medium from the
plate containing sterile Sabouraud’s agar Pick up the block of agar by inserting the
scalpel and carefully transfer this block aseptically to the centre of the slide.
Aseptically, place a sterile cover slip on the upper surface of the agar cube.
Flame the inoculating loop until red hot Take the plate containing fungal culture to
be examined Remove a small amount of fungal culture from
the plate Inoculate four sides of the agar square with
spores or mycelial fragments of the fungus to be examined
Cover the Petri dish and incubate at room temperature for 48 hours.
After 48 hours, examine the slide .Mycelial growth and spore producion is observed through
the four corners the agar cube spreading over to the cover slip.
Procedure for Application of Stain Place a drop of lactophenol cotton blue stain
on a clean microscope slide. Remove the cover glass from the slide culture
and discard the block of agar place the cover glass with mold grown side
down, on the drop of lactophenol cotton blue stain on the slide.
Examine the slide under low power and then high power objective of the microscope.
Morphological features of the Fungi was observed. Slide culture method is more advantageous
as there is no need to remove a portion of the fungus from a culture plate and transfer
it to the slide. Thus there is less chance for the features that are key to identification,
notably the spore-bearing structures, to be damaged. • By doing this, there is no need to remove
a portion of the fungus from a culture plate and transfer it to the slide. So there is
less chance for the features that are key to identification, notably the spore-bearing
structures, to be damaged.

9 Comments

  • Reply Alanazi Meshal August 4, 2012 at 9:33 pm

    excellent explanation

  • Reply Jeric algarme December 19, 2012 at 12:34 pm

    easy to see, but it's hard to do. lalo na pag aseptic technique.

  • Reply nad5983 February 21, 2013 at 8:35 am

    Thank you very much for this video!

  • Reply Abdulhadi Saqib February 28, 2016 at 5:12 am

    tnx for chronological stepwise presentation……………

  • Reply unknown December 8, 2016 at 9:07 am

    very well

  • Reply Sima Moha May 11, 2017 at 5:15 pm

    very nice

  • Reply Sima Moha May 11, 2017 at 5:18 pm

    I am astudent of laboratory departiment i benefited a lot thanks

  • Reply Shafi Alam May 27, 2017 at 10:06 am

    useful…

  • Reply Manjiri K September 12, 2017 at 5:47 pm

    Very well demonstrated tysm

  • Leave a Reply